Illustration 1.
WARNING
Do not drill & attach the tool-holder to the end of that grill that has a burner. Always use the end of the grill that has a table and no burner.
Installation of the hooks.
The hooks have been removed from the tool-holder to prevent any damage in shipping.
Using only your hand. simply screw the hooks into the pre-drilled holes in the tool-holder.
For installation of tool-holder to BBQ grill.
1. Measure from point A to point B, Place the tool holder evenly from each end of the grill.
2. Line the top of the tool holder flush with the top of the BBQ grill tray.
3. Holding the tool holder firmly, now take a 1/4" drill bit and drill to mark the place to be filled for bolts.
4. Move the tool holder away from the grill and using the same 1/4" bit, drill the hole on each end
of the table.
5. Fasten the tool holder in the pre- drilled holes and insert the bolt in each end of tool holder.
6. Reach behind the grill tray with one hand, fasten the wingnut to each bolt. Tighten each wingnut with your fingers only.The only tools you will need for the
drilling process are a high speed drill and a 1/4" drill bit.
After installation occasionally check the wignnuts to insure that they are always tight.